Laing Ecocirc Hot Water Recirculating Pump with Adjustable Thermostat, Built-in Ball and Check Valve, 1/2" Sweat Union Connections and Bleeder Valve from the E Series

ecocirc E Series Domestic Hot Water Pump

The first pump to run off of 10 Watts - about the same as a night light!

Ecocirc Pump Features :

• Easy Installation
• Adjustable Thermostat
• Saves 68% electricity compared to a standard circulating pump
• Long lasting, silent operation
• Highly Efficient ECM (Electrically Commutated Motor) technology
• Instant availability of hot water, even at the farthest tap from the water heater
• Resistant to scale build up
• Conserves natural resources - reduced power consumption, CO2 emissions and wasted water
• No shaft, no seal
• Maintenance free without blockage
• Single bearing design
• Includes check and ball valve

Technical Data :

• Motor Design - Electronically communtated shaft less spherical motor with permanent magnet technology
• Power Consumption - 10-28 Watts Maximum
• Max System Pressure - 145 PSI (10 Bar)
• Electrical Connection - 100-240 V, 50/60 Hz
• Maximum Fluid Temperature - 203° F (95° C)
• Protection Class / Insulation - Class F / IP 55

Adjustable Thermostat :

For models with the adjustable thermostat, there is an adjustable
Set Point range from 68ºF to 158ºF (20ºC to 70ºC). This built-in
temperature sensor will turn the circulator off when it reaches the
set point and turn the circulator on when the temperature is more
than 10ºF (6ºC) below the Set Point.

Optional E Series Timer :

To increase the overall efficiency of a domestic hot water recirculating system and to reduce water wasted while waiting for hot water, the E series Timer can be installed on all E series pumps. The timer is easily installed by removing the motor end cap, plugging in the timer and setting the timer schedule without any wiring. The timer can be used in 3-different selections: ON, OFF and TIMER. The ON selection operates the pump continuously, the OFF selection turns the pump OFF and the TIMER selection (depicted by a clock on the timer) turns the pump on when programmed.